Lumbeck & Wolter (L&W) knives and plates are our Premium range.
This tool steel #12 plate has
4.5mm holes and is
double sided with 1 notch.
►Its mincing holes are 4.5mm or 3/16 inches.
►Diameter #12 ~ 70mm (approx)
►Center hole is 10mm
►This doubled sided plate can be flipped over and the other side used to double the longevity
►This plate does
not have a hub
►Manufactured in Germany from tool steel (not stainless steel)
►Recommended that you use a M&W knife with a M&W plate
►Change your plate and knife together, to ensure an efficient usage of your machine
Care instructions for good working and long lasting life of Lumbeck & Wolter meat mincer plates & knives:
- Always use the same make of plate & knife together
- Never tighten too hard plate against knife
- Never run the meat mincer without product
- Make sure that the square spindle is not badly worn
- Always wear gloves when handling
- Wash plate and knife with hot water only. Dry well to prevent rust spots as this is manufactured from tool steel not stainless steel