Lumbeck & Wolter (L&W) knives and plates are our Premium range.
This tool steel #32 plate has 3mm
holes and is double sided
with 3 notches for a universal fit.
►The mincer plate has an approx diameter of 100mm.
►Centre hole is 13.5mm.
►This doubled sided plate can be flipped over and the other side used to double the longevity.
►This plate does not
have a hub.
►Manufactured in Germany from tool steel (not stainless steel)
►Recommended that you use a L&W knife with a L&W plate.
►Change your plate and knife together, to ensure an efficient usage of your machine.
Care instructions for good working and long lasting life of Lumbeck & Wolter meat mincer plates & knives:
- Always use the same make of plate & knife together
- Never tighten too hard plate against knife
- Never run the meat mincer without product
- Make sure that the square spindle is not badly worn
- Always wear gloves when handling
- Wash plate and knife with hot water only. Dry well to prevent rust spots as this is manufactured from tool steel not stainless steel